Water baths are found in many different lab settings and are used in educational settings as well, such as universities and schools. There is a wide range of uses so it’s important to have this piece of equipment. Whether or not you are currently using a water bath for lab equipment or hoping to purchase one, there are a number of things you should know.
A water bath is a piece of equipment that is a heated water container. Many scientists use them to incubate different samples and keep the samples at a consistent temperature. Almost all laboratories have a water bath since it’s a useful heat source for different devices. When the water circulates in the bath, the temperature remains consistent throughout use. Water baths are made up of a heating unit, a control interface, and a water chamber.
How Are Water Baths Used?
Even though water baths have many different uses, the main use is to heat up samples in a lab and to heat flammable chemicals. Flammable chemicals can be at risk of combusting when exposed to an open flame.
A water bath works with a temperature sensor, which works by transferring the water temp to the resistance valve and then working with an integrated amplifier. The control signal controls the average heat to have a constant temperature in the bath.
Types of Water Baths
There are different types of baths that are used for different applications. For example, a shaking water bath is used to keep the samples in a consistent motion when heating. There are key benefits to a shaking water bath, including bath drains, adaptable shaking options, user-friendly operation using a keyboard, and cut-off protection for high or low temperatures. A circulating water bath just keeps the temperature constant. Most baths will heat samples to between 5 and 99 degrees. In a non-circulating water bath, the bath relies on convection instead of the water being heated uniformly. This type of bath is less accurate when it comes to temperature control. There are also some add-ons that can stir a non-circulating bath to keep uniform heat transfer. If a sample needs to be heated to higher than 100 degrees, then there are other alternatives, such as a silicone or sand bath.
How to Use a Water Bath
To prepare the bath, you should fill it to the desired level using distilled water. You then switch the bath on using your required temperature on the controller. You need to wait until the bath has reached the right temperature. How long this will take will depend on the temperature you need. You may want to use a thermometer in order to monitor the temperature. Once it has reached the desired temp, then you can start using it. It’s easy to use a water bath, but you should make sure you are using it correctly in order not to compromise or damage the samples.
Make sure the surrounding area is clean and dry. Be sure to connect the power supply and remember that you need to have the water at the right level so that it’s high enough to cover the heating element. Once the thermostat shows it is heated enough, you can add your samples. After you are done using it, remove your samples and switch off the bath.
Maintaining a Water Bath
No matter what type of water bath you are using, if you want to prolong its use, then you need proper maintenance. It’s important to consider the type of water you are using. Distilled water is preferred because tap water usually has minerals that can build up in the bath over time. You need to make sure you correctly drain the bath after every use in order to keep it in good condition. Make sure you clean the equipment regularly. To clean it, be sure it’s off and remove the container. Wipe down the seal to remove debris, but be careful not to get water into the unit since it can damage the electronic parts. Don’t use any corrosive cleaning agents in the bath and only use a mild detergent and a damp cloth when cleaning.Read Full Article